How do you set the sharp atomic clock on a SPC900?

How do I set the time on my sharp atomic clock?

Time and Date

To access the settings screen on the Sharp atomic clock, hold down the “Time” or “Month/Day” buttons for three seconds, then use the up and down arrows to increase or decrease the number values to the desired time or date.

Why is my atomic clock not working?

Try powering down the clock (unplug it or remove the batteries), then turn it on again to see if it synchronizes. If the clock uses batteries, check them and replace if necessary. If the radio controlled clock is a desk top unit, try rotating it 90 degrees.

How do I reset my sharp atomic clock model spc364?

* If all else fails, (at night) insert the tip of a bent paperclip into the [RESET] hole in the back of the clock to press the internal reset button. Then press the [RECEIVE] button to make the clock seek the atomic radio signal and set itself automatically.

How long does it take for an atomic clock to set itself?

When you turn a radio controlled clock on, it will probably miss the first time code, so it usually takes more than one minute to set itself (sometimes 5 minutes or longer) depending on the signal quality and the receiver design.

IT IS AMAZING:  You asked: What does sleep mean on a clock?

Why is my atomic clock not resetting?

If your clock did not change with Daylight Savings Time (DST), make sure the DST switch on the back of the clock is set to ON. If your clock is off by increments of an hour, the Time Zone (TZ) is set incorrectly. Check the Time Zone switch on the back of the clock. If the problem persists, we have a one year warranty.

Will an atomic clock set itself?

Atomic clocks set themselves and automatically adjust for daylight saving time (DST) to provide the most accurate timekeeping standard possible.

How do you reset a marathon atomic clock?

This Marathon atomic clock is self-adjusting and self-setting, eliminating the need to manually input the time and date. Simply insert the batteries provided with the clock and it will synchronize to the time set out by the atomic clock in Colorado once the signal is received.

Why is my atomic clock spinning?

Hands may spin if the battery is under powered or over powered. Daylight Saving Time: The National Institute of Standards and Technology and WWVB encode a special DST “bit” in the WWVB transmission for DST. If you live in an area that does not recognize DST, you must slide the DST switch OFF.

How do you reset a radio controlled clock?

Radio-Controlled (MSF) Clock

  1. Insert a new AA battery.
  2. Press Reset button at the back of the clock, the clock hands will go clockwise and it will automatically set itself to the correct local time.