How do I reset my digital atomic clock?
Press any button to stop the alarm for 24 hours. If the atomic clock display appears distorted or is not responding to buttons, use a pen or paper clip to press RESET one time. This will reset the atomic clock to default settings.
How do you reset an automatic clock?
Press and hold the “REC” button (D) for 3 seconds. The clock will search for the atomic signal. The clockʼs hands will move to the 12:00 position and the atomic signal will be received within 3-12 minutes. Once the atomic signal has been received, the clock will set itself to the correct time.
Why is my radio controlled clock not working?
Check that the power supply is in full working order. Change the current battery for a fresh one and reset your clock. … Try rotating the clock. Most radio-controlled clocks have an internal antenna that picks up the signal most effectively when it is facing directly towards or away from Anthorn.
Why is my automatic clock wrong?
Low batteries are often the cause for weak reception. Relocate the clock. … If your clock did not change with Daylight Savings Time (DST), make sure the DST switch on the back of the clock is set to ON. If your clock is off by increments of an hour, the Time Zone (TZ) is set incorrectly.
How long does it take for an atomic clock to reset?
When you turn a radio controlled clock on, it will probably miss the first time code, so it usually takes more than one minute to set itself (sometimes 5 minutes or longer) depending on the signal quality and the receiver design.
How can I get my atomic clock to adjust to DST?
Hold the ZONE button for 2 seconds to switch from DST ON to DST OFF. *If your location observes Daylight Saving Time, this setting must always be turned ON so the clock can adjust properly for the time changes. If your location never observes DST, this setting should always be turned OFF.
Why did my atomic clock lose an hour?
If the atomic radio controlled clock is off by one or more hours, it probably has to do with the time zone setting. Make sure the time zone has been properly selected using the instructions that came with the clock. … When purchasing a clock, make sure that it can display the correct time zone.
What does M Set mean on a clock?
MANUAL TIME SETTING
Press and hold the Manual Time Set Button (M SET). The second hand will stop and the hour and minute hands will do a fast advance.
Why is my atomic clock spinning?
Hands may spin if the battery is under powered or over powered. Daylight Saving Time: The National Institute of Standards and Technology and WWVB encode a special DST “bit” in the WWVB transmission for DST. If you live in an area that does not recognize DST, you must slide the DST switch OFF.
How do you set the time on a pendulum clock?
Stop the pendulum to move the pendulum bob up or down to change the pendulum’s effective length. If the clock is running fast, move the bob down or turn the nut to the left. If the clock is running slow, move the bob up or turn the nut to the right. Restart the pendulum and reset the clock hands to the proper time.