How does Emerson Smart Set work?
Our Smartset technology automatically sets your clock to the correct Year, Month, Day and Time as soon as you plug it in. Just select your time zone and the built-in computer does everything else for you immediately.
How do you turn up the volume on a Emerson alarm clock?
Press Vol+ or Vol- to set the maximum radio volume at which the alarm will reach gradually at wake up time. Default alarm volume is U08 for radio volume set up between UOO-U08(before the unit turned OFF to standby mode). For a louder alarm , set up radio volume above U08 before the unit turned OFF.
How do you turn on a Emerson Smart Set radio?
Press the RADIO ON/OFF button to turn the radio ‘On’. The frequency of the tuning frequency will show for a few seconds on the display. 2.) Set the BAND by pressing button to AM or FM as the desired, it toggles each time you press the button.
How do I turn off my Emerson smart set alarm?
Look at the buttons on the left side of the clock. The top ones control alarm 1, the middle ones are for alarm 2, and the bottom ones are for the dimmer. Slide the middle button all the way down and that should turn off alarm 2.
How long does it take for an atomic clock to set itself?
When you turn a radio controlled clock on, it will probably miss the first time code, so it usually takes more than one minute to set itself (sometimes 5 minutes or longer) depending on the signal quality and the receiver design.
How do I set my Emerson Research clock?
To manually adjust the time display depress and hold the TIME button, and press either the SET + or SET – buttons to adjust the time display ahead or back as desired. Each press of the SET + or SET-buttons will change the display by one minute. If you hold the SET + or SET – buttons the display will continue to change.
How do I connect my Emerson Bluetooth speaker?
Turn on the Speaker by holding the Standby button. The Bluetooth indicator will start to flash rapidly after a short time. The Device Is now set to the pairing mode.
How do I turn off the alarm on my Emerson Radio?
Example: The bell icon is visible in the upper left corner on the clock face, and the alarm sounds at the appointed time. Pressing the button AL1 once will change it to wake with the radio and display a music note icon. Pressing it again will remove that icon and the alarm will not go off.
How do I set my Emerson smart set alarm?
Press and hold the button labeled Alarm 1 to activate the alarm time adjustment. While holding the button, use the Tune up or Tune down control options. The changes work in the same manner as changing the general time. Select and hold the Alarm 2 button and use the same controls to adjust the time.