Your question: Can you replace the battery in a Timex watch?

How do I change a Timex watch battery?

How to Change a Watch Battery

  1. Remove the watch back. Most modern watches have snap-off back panels, which have small indentations to help you carefully pry off the cover. …
  2. Place the gasket to the side. …
  3. Find and remove the battery. …
  4. Insert the new battery. …
  5. Test your work. …
  6. Replace the gasket and watch back.

How do you take the back off an old Timex watch?

Locate the small screws on the back of the Timex face and use your small Philips head screwdriver to remove each screw. Place the screws in a safe location and notice the notches on the back of the watch plate. There are small notches surrounding the outside of the back plate and these are used to pry the plate open.

How long does a Timex watch battery last?

However, on previous similar Timex watches the batteries lasted 3 years or so. Do you find this helpful? Hello Charlie! Generally batteries last for 3-5 years but dependent upon use as well.

How much does it cost to change a watch battery?

On average, most professionals are going to charge around $5 to $14 to replace a basic watch battery, but this can greatly vary depending on the brand and type. Watches with a water resistant battery can cost $40 to $65, whereas chronograph models can cost as much as $65 to $100.

IT IS AMAZING:  How do I set the time on my Timex Expedition?

Does Walmart replace batteries in watches?

Even though they do not offer a battery replacement service, Walmart does stock kits for easily replacing watch batteries and removing watch links. … Alternatively, you can take your watch to a jeweler or watch-smith.

What is the difference between CR2016 and CR2032?

CR 2032 has a capacity of 240 mAh, while CR2016 has a capacity of just 90 mAh. The CR2032 can provide 10 hours of use, while you only get about six hours from the CR2016, depending on the power you’re using, of course. Due to their equivalent voltage, there are several cases where CR2016 and CR2032 can be interchanged.

How do you take the back off a stubborn watch?

Pour a little acetone (nail varnish remover) into the socket and leave it for a minute or so. Empty out the excess acetone back into the cap of the bottle, attach the socket back on the wrench and give the case back a tap with a rubber mallet or something that will give it a bit of force but not mark it. Job done.