How do I reset my marathon wall clock?
This Marathon atomic clock is self-adjusting and self-setting, eliminating the need to manually input the time and date. Simply insert the batteries provided with the clock and it will synchronize to the time set out by the atomic clock in Colorado once the signal is received.
How long does it take for an atomic clock to reset?
When you turn a radio controlled clock on, it will probably miss the first time code, so it usually takes more than one minute to set itself (sometimes 5 minutes or longer) depending on the signal quality and the receiver design.
How do I reset my digital atomic clock?
Press any button to stop the alarm for 24 hours. If the atomic clock display appears distorted or is not responding to buttons, use a pen or paper clip to press RESET one time. This will reset the atomic clock to default settings.
How do I reset my sharp atomic wall clock?
The clock will automatically leave manual mode after the SET button is not pressed for 6+ seconds. If the clock does not respond to the various function modes, you can reset the clock by pressing the RESET button on the movement case.
Why is my atomic clock not working?
Try powering down the clock (unplug it or remove the batteries), then turn it on again to see if it synchronizes. If the clock uses batteries, check them and replace if necessary. If the radio controlled clock is a desk top unit, try rotating it 90 degrees.
How do you set the time zone on a marathon atomic clock?
To change the time zone, press and hold the “+ 12/24” button on the back of the clock for approximately 4 seconds.
Why is my atomic clock not resetting?
If your clock did not change with Daylight Savings Time (DST), make sure the DST switch on the back of the clock is set to ON. If your clock is off by increments of an hour, the Time Zone (TZ) is set incorrectly. Check the Time Zone switch on the back of the clock. If the problem persists, we have a one year warranty.
How can I get my atomic clock to adjust to DST?
Hold the ZONE button for 2 seconds to switch from DST ON to DST OFF. *If your location observes Daylight Saving Time, this setting must always be turned ON so the clock can adjust properly for the time changes. If your location never observes DST, this setting should always be turned OFF.
Why did my atomic clock lose an hour?
If the atomic radio controlled clock is off by one or more hours, it probably has to do with the time zone setting. Make sure the time zone has been properly selected using the instructions that came with the clock. … When purchasing a clock, make sure that it can display the correct time zone.
Where are the time changes?
Most of the United States and Canada observe DST on the same dates with a few exceptions. Hawaii and Arizona are the two U.S. states that don’t observe daylight saving time, though Navajo Nation, in northeastern Arizona, does follow DST, according to NASA.